Ottobre 3/2012

Ottobre – 3-2012 #26 Hula-Hoop Bubble Shorts

Things I Learned

  • Pockets – I really like this pocket design!  Love that they are on the side of the shorts and have elastic on the top.
  • Faux fly – I’m pretty sure I followed the instructions correctly, but I don’t know that I like the results.  I am questioning why the pattern goes through the trouble of including the faux fly panel when in the end it’s folded to the inside of the shorts and you have to top stitch the outline of it.  I ended up having to manually draw the outline so I could topstitch it correctly.  The faux fly has an opening and I just knew I would be annoyed that it would always be hanging open, so I closed it up with some Stitch Witchery…
  • Waistband – This was the first time I made an elastic waistband where the fabric wasn’t all ugly and scrunched up in my stitches!  I learned the secret: pull the elastic so the fabric is taught as you sew the casing closed!
  • Belt loops – My first time doing these.  Turned out ok.  The instructions hinted at looking to the “design illustration” for locations to place the loops, but there was no picture of where the back ones should go.  It also seems like their illustration has them lower down than mine so they must not have put them in the waist seam like I did.
Ottobre 3/2015

Ottobre – 3-2015 #15 Lionella Jersey Dress

Things I Learned

  • Sleeves – It took me awhile to figure out what the instructions for the sleeves were describing.  From what I read I thought it was going to have some exposed seams which I didn’t think was correct!  Finally I pinned the pieces to replicate where I thought they would be sewn and understood what I needed to do.  Sometimes it’s just easier to play around with it than try to imagine the next steps!  Unfortunately the length of elastic tape I used was too small for my daughter’s arms — the sleeves were a little too tight.  Next time I will measure her arms first to confirm the elastic length!
  • Back strap – I was worried about how the strap across the back would turn out and I was actually pleased with the result.  I was afraid it wouldn’t be tight enough and would hang loose, but it was nice and tight.
  • Ruffles – Attaching the bottom ruffle to the bottom of the skirt panel went fine, but I had a big battle with the upper ruffle.  I’m still not sure if it was due to a mistake on my part, the type of fabric I used, or what…  For some reason my skirt panel was about 7 inches bigger than the top ruffle and I’m pretty sure stretching the ruffle wasn’t going to make up enough of that difference.  I ended up having to gather the top of the skirt panel.  It worked out ok, can’t be seen from the outside of the dress, but I know it isn’t perfect.  😦
  • Bodice size and length of dress – The bodice ended up being too small for my daughter even though the 110 size was actually supposed to be a little big for her.  You can see in the pictures the bodice is pulling in strange areas.  The length of the dress is too short too.

I ended up giving this dress to a friend’s daughter who normally wears a size 3T…  The bodice is a little roomy for her, but actually looked ok loose-fitting like that.  The length was perfect for her.  I’m still not sure if I made a mistake somewhere or this size was not right for my daughter.  If I try this dress again I’d probably go up a size or do some custom pattern changes to the bodice.  Perhaps make it longer and wider.

I really wanted this dress to work!  It’s such a cute design.